Berryaudio Community

After installing Berryaudio

-Connecting to Network
-After the Pi finishes booting, it will start in AP mode.
-You should see a Wi-Fi hotspot named berryaudio. Connect to this network from your device.

and now i need a pin for login 4-8 numbers.

The Wlan Passwort is: 1234567890 but on my Windows PC i can enter only 8 numbers. With my Android Phone i can use the access on the browser.

Thanks for the information but you could elaborate about your windows issue with only 8 numbers ? Can you share what Windows version are you using ? So i can try to reproduce the issue on my side

is there a way to force it back to AP mode? I'm using a Rpi zero which only has one interface onboard and I'd like to use it on a portable device

apologies, I disconnected from the wifi, and it defaulted back to AP mode.

I just checked the windows password requirements, your right it does ask for 8-13 charachters i will adjust the default AP password for the next release so it works for windows.

Please update the documentation. The password was berryaudio which is still in the Getting Started document. I found another password which said it was 1234567890. I found this thread to find it was changed to 8 charceters and it is now 12345678. Wasn't hard to figure out but time a little frustrating