Berryaudio Community

I've been attempting to run Berryaudio on my Raspberry Pi Zero W with no success. I've downloaded the latest image and loaded it onto a SD card via the Raspberry Pi Imager, as recommended. When I power the Pi Zero, the ACT LED blinks 7 times -- which I've read means that it cannot find the kernel image on the SD card, and therefore not booting.

Has anyone ran into this issue on the Pi Zero W? If so, what steps are needed to make the image boot?

I just resolved this problem with my zero 2 W by changing to a more powerful wall plug. I wouldn't have understood the issue if not connecting to a monitor, it would basically just reboot endlessly, and when I got a new plug it booted just fine.